Hayward Chlorinator Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handle / wrench to fit the top of the smaller Hayward CL200 automatic chlorinators.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This wrench fits many Hayward CL200, CL220 and other chlorinators with the 6 "knobs" on top. Note that this is a SMALL chlorinator. If you are looking for a wrench for the larger Hayward chlorinators, dankvwguy has done a remix that should work.
After several years of age, my chlorinator required me to use a very big pair of channel locks to tighten the top on enough to maintain a seal and prevent leaking. Even a new gasket didn't help. I got tired of bringing out the channel locks every time I needed to add chlorine so I created this wrench.
The fit is intentionally a bit loose to make it easy to get the wrench on and off.
I used PLA+ for the material with 40% infill. After several uses, I haven't had any problems with strength or deformation of the wrench.
You can also buy these for about $25 on Amazon, but I preferred to design and make my one for ~$0.69 :)