Light Holder without supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slightly modified version of the light support with FDM printing design optimizations
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this remix to better fit my needs. Since I made my own LED board, I made it with a higher light output, thus requiring more heat dissipation.
I needed to add a heatsink, and to prevent long heat exposure deformation, I also wanted to print this part in ASA. I wasn't able to get good supported surfaces, so I simply redesigned the part to be printed without supports.
The screws required for mounting the LED holder to the Arm Connector are the same ones used for mounting PC fans to cases. In case you don't have them in hand, you can grab the STEP file and modify the design as you like
More changes were made, so check the differences below and see if this model fits your needs!