Dual Spool Hanger | Hanging Dual Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to print hanger for two filament spools.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I have been changing up my printing enclosure and wanted to add a dual spool holder and this is what I came up with after looking at other options for a few minutes. This prints in three separate pieces and it requires M3 screws, at least 10-12mm probably, but I used 30mm because I had lots of options. You can probably get away with just using 1-2 screws on each end but of course there are holes for 8 so choose your own adventure. The screw holes to mount the entire thing are sized for Kreg pocket hole screws but should fit many standard wood/machine screws. Holes are 4.4mm/9.5mm.
I would recommend printing the column laying down so you can benefit from both the accuracy of a low-Z print and also the strength in that direction but realistically if you have good layer adhesion it should not matter. I used supports on the screw hole overhangs on the base and arm and nowhere else.
I'm open to modifications if you come up with an improvement or would love to see your remixes if you care.