Kallax and Billy Vertical Boardgame Brackets – No More Stacks

My 3D-printable brackets  turns your IKEA Kallax (and Billy if you want) into a properly organized board game shelf. No more unstable stacks. No more game-Tetris. Just clean, vertical storage.

🔧 What does it do?

• Mounts directly inside a Kallax compartment

• Upgraded: It now suppors Billy shelves. With the Spacers for Top and Bottom you can mount the brackets in the middle of a Billy shelve (see photos or write me if you have questions how to install it into a billy shelve. You can decide if you use Version01 or Version02

• Allows you to stack the boxes horizontally, but not directly on top of each other.

• I chose the spacing to support various typical box heights, so the same number of boxes should fit into a Kallax cube as if they were stacked directly on top of each other.

🖨 Print Details

• Just use supports for the drilling holes. The supports can easyily popped out with a screw driver

• Includes a printable spacer tool to ensure each bracket is mounted at the exact correct height

• And I added a block (50*200 mm) with which you can easily measure the distance from the edge

PLA works great. If your collection is getting out of hand, PETG or PLA+ adds some extra durability 😉

🛠 What else do you need for installation?

• Screws: 3 × 16 mm chipboard screws

• Wood drill bit, approx. 1 mm (for pre-drilling the holes)

• Wooden rods, 10 mm diameter
  (I used round dowels, but square ones might work as well)

• Basic tools

If you have improvement ideas or need a slightly adjusted version (different height, spacing, etc.), feel free to leave a comment.

(This description is made with the help of AI)