Wegovy FlexTouch pre-filled Pen and Needles Holder / Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This 3D printed holder for the Wegovy FlexTouch pre-filled pen ensures safe storage and convenient travel use.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 418
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This 3D printed holder for the Wegovy FlexTouch pre-filled pen ensures safe storage and convenient travel use.
I based the needle plunger on an insulin pen case design that I have been using for a couple of years. Have a look at the great pen case designs by Zvedak on Thingiverse. Specifically, thing 5441360.
The holder is meant to house and protect the Wegovy FlexTouch pre-filled pen and its accompanying needles, providing a safe and compact case for both home use and travel.
For optimal strength and durability, it is recommended to use high-quality PLA or PETG filament with a layer height of 0.2mm and a wall thickness of 1.2mm. Brim might be necessary to prevent warping.
Assembly Instructions: Insert the Pen in the larger round cavity. Inset the plunger part-way in the smaller round cavity and load the dispoable needles down the tube. Push the plunger down to securly store the needles. Slot the cap over the top of the case / container. Release the cap by pushing on the sides (long edgse) of the cap and pulling it away from the case.
Print Settings File and Plates:
5 Plates set in PLA
You only need to print plates 1 & 2 for the full Case / Holder set, the rest are alternate options
Plate 1: Wegovy Case Base Holder Plate 2: Cap and needle plunger for the holder
Plate 3: Optional Loose Fitting Cap
Plate 4: Optional Tight Fitting Cap
Plate 5: Plunger only