K1 Max Louvre Exhaust With Carbon filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaces the stock carbon filter with a refillable carbon box with louvre flaps to keep the heat in.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 233
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print Notes:
No support needed.
Layer Height
All bar the flaps, 0.2 mm
Flaps, 0.1 mm (0.2 works, but 0.1 give better outcome)
Extrusion width
Set to 0.4 on all, otherwise the mesh will not be generated., also watch out for elephant foots compensation as that can also cause the first layer mesh to not be generated.
Gen Notes:
You will need to remove the two ears that hold the standard carbon filter in place with a knife or pair of snips.
You need to glue the top brace to the main body, just make sure you have it seated correctly first.
The K1 Max exhaust fan is not exactly what you would call high static pressure and the intake is quite restricted, so dont expect the flaps to be out at 90 deg :)
I have included an optional O-ring that if used should be printed in TPU with one wall and no infill.
If the main body is printed with a slight over extrusion the flaps will sttick, use a 3.5mm drill bit to bore the flap pivot holes out to size if this happens.