GlowNut & GlowerStick; Glowing zipper charm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A glow in the dark nut and another shaped like a glow stick, each with a hole to hang from ropes or zippers.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
NEEDS TO BE DONE IN A GLOW IN THE DARK FILAMENT
Heyy :3
Im back at it again but this time with some very usefull prints.
Tired of not being able to find where your darn zipper from your back pack is in the dark? I am atleast, I searched a solution and stumbled upon something called "the glownuts"; 7$ per 2 units + shipping. Shortly following, I remembered that I had some gitd filament lying around, I quickly designed something similar in Sharp3d and Im not disappointed with the results :^
The holes both in my GlowNut and in the GlowerStick are both 5mm in diameter, enough to stick a rope or any kind of line that needs to be spotted in the dark through.
Its not super bright but definitely enough to get by.
I added my logo in the bottom of the GlowerStick.
Print notes:
I’d advise a high infill, the higher, the more it glows, I haven’t tested if layer height makes a difference.
I used Bambu Lab's blue gitd filament with no supports on the x1c.