Insta360 handle holder for Seacraft DPV GO!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model is to secure the Insta360 camera's extension stick on the DPV Seacraft GO in the front upper handle.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This model will hold the front part of the extension stick for the underwater camera Insta360 X4/X5 on the DiversPropulsionVehicle Seacraft GO! in it's upper front holder. It has to be secured on the back of the DPV with other holder to be totally secured on the DPV for stability and easy retractability or extension during the dive. It was tested underwater and it is more stable than securing the camera stick with the bungees.
I put two M5 short inserts for the side part but no place for it on the top part so there is only a small hole for raw screw.
M5x15 screws needed.
I used ASA filament because it will be stored in the truck during hot days and It's so fit (20mm hole) so any bent should avoid the stick pass through.
Feel free to comment or make any suggestions for improvement.
Happy printing and diving.