Parametric grdifinity LARGE SMD tape holder V3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The tape holder width is parametric and so is the base grid amount based on a 35,5 x 35,5 gridfinity base.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
This model features a fully customizable width for a 20mm diameter SMD tape holder. The width can be specified (in FreeCAD) via the VarSet.tape_holder_width parameter. Also, the number of tiles the grid occupies can be set with the VarSet.grid_numbers variable.
Changing the width will also show how many of them will fit.
I'll include in the files only the base for the holders, since the 8mm and 12mm tape holders can be already downloaded from the JDA remix of the part.
HOW TO USE
You can choose both the number of gridfinity tiles and the holder width via the VarSet in the FreeCAD project:
You will notice there are 5 variables, 3 of which are colored blue and are used to make all the calculations (do not change them) and the other 2 are white and can be tuned to get your designed layout.
If you want to use the version without the dividers, just toggle the visibility of the models by selecting all and either press space bar (default visibility toggle) or right click -> toggle visibility .
Changelog:
V2:
Made parametric base with dividers
Made parametric tape holders width
Better clearance on holder clip
V3:
Added a version without dividers to fit more holders with 0.2mm clearance
Holders spacing is now calculated based on total length (before it was calculated on a single cell and then multiplied, which caused a lot of space waste)
Fixed issue where dividers clipped into the holders for some holders width