X52 Pro Bayonet Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The connectors on the X52 /Pro are a bit flimsy. This holds them in place and protects them from bending/damaging. It…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Share Alike
The connectors on the X52 /Pro are a bit flimsy. This holds them in place and protects them from bending/damaging.
It is basically like this https://www.thingiverse.com/thing:2564232 part from thatdude902 but easily reconnectable with a bayonet (twist-lock) mechanism.
.stp and .ipt (Inventor) source files included. When using those, please honor the license (cc - share alike).
Print Settings
Supports:
No
Resolution:
0.1 to 0.15 mm
Infill:
40 %
Notes:
Print slowly and prevent blobs at all costs (enable coasting, retraction, ..). The fit is not too tight, but if it is for you, just scale up the "base" part slighlty.
Post-Printing
Assembly
Stick the base part to the x52 with thin double sided tape.
For easy alignment, put the connector through the base hole and connect it to the X52 first. The base part is now dangling from the cable.
Now connect the plug part to the base part (cable goes through slot) and push the assembly over the connector until it sticks to the X52.
Goes without saying: befor applying the tape, clean the surfaces with alcohol!
(Re-) Connection
Its easiest to always plug the connector into the X52 first and then slide the protection over the connector and twist-lock it to the base part.