MSA Millennium Outlet Cover and Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Outlet cover for the MSA Millennium (and similar), also with a 1/4 inch hole for mounting camera gear.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Costume Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a replacement cover for the MSA Millennium gas mask outlet. It uses M3x20mm screws to hold it together. The holes are snug, so nuts may not be needed, but there are provisions for them for a stronger hold.
One of the top parts has a 1/4 inch hole in it, to allow for mounting camera gear to it. The image shows an action camera mounted to it with a short 1/4 inch screw holding it on.
Parts to secure to the mask:
Screws:
https://www.mcmaster.com/90128A204/
Nuts:
https://www.mcmaster.com/93625A100/
Washers:
https://www.mcmaster.com/93475A210/
Camera mount screw:
https://www.mcmaster.com/90015A394/
Other similar hardware may be better for your needs, the above links are only examples for reference.
Print as oriented in the CAD photo. The tops may need support, but I printed them without with minimal sagging. Prints best with 0.4mm nozzle or smaller. Use at least 5 walls and solid infill for mounting camera gear.