Anycubic Kobra S1 Door Seal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Anycubic Kobra S1 Door Seal I'm not a fan of rattling doors, and I wanted them to be airtight. So I developed this sea
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 120
- Wydruki
- 3
- Wyświetlenia
- 1058
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Anycubic Kobra S1 Door Seal
I'm not a fan of rattling doors, and I wanted them to be airtight.
So I developed this seal.
Simply cut along the cut marks, then insert it without needing any glue.
Printed with eSun TPE Filament 85A. If you have it and are able to, you can use a softer filament.
Printed with the following settings:
LW 0.4 LH 0.2
Wall loops 3
6 Top/Bottom shell layers
Top surface concentric
The overhangs are tricky. If all parts are printed together, "Bridge counterbore holes - Partially Bridged" should be enabled.
For better results, print them one after the other.
I've attached the Anycubic Slicer 3mf project file.
I've also included a 50mm test piece.
Since then, the Kobra hisses even more quietly ;-)