I plan to configure the support settings later to make removal easier. Also I may make some modifications to remove the need for supports on unit cells like FCC - which have difficult to access support material.
I also plan to make a more accurate model of the HCP unit cell, a more accurate model will require structural supports or assembly.
Includes models for Body Centered Cubic, Simple Cubic Cell, Face Centered Cubic, Hexagonal Close Packed ( two versions ).
If it isn't obvious to you, I would recommend using supports, as this model would not print well without them.
Also, I would recommend increasing the number of wall loops / perimeters (at least 4) to ensure the atom segments do not easily break. There are hidden structural beams connecting each corner atom / central atom; a thicker wall will help with rigidity.
Print Settings:
Infill %
15-20
Infill Type
Gyroid (optional)
Wall Loops / Perimeters
4
Materials Needed:
10mm diameter magnet , ( ~ 1.5 ~ 2 mm) thick - [BCC, SBC, FCC] (24 magnets for each cubic unit cell)
