1 / 3
Kona Satori (2013) Rear Brake Hose Guide - Fix for Modern Shimano Calipers (Inner Hose Routing) — zdjęcie 1
1 / 3

Kona Satori (2013) Rear Brake Hose Guide - Fix for Modern Shimano Calipers (Inner Hose Routing)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A heavy-duty replacement for the rear brake hose guide on the 2013 Kona Satori. Essential when upgrading to modern Shima

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
50
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

THE PROBLEM: OLD FRAME VS. NEW BRAKES

I designed this part to replace the missing original cable guide on my 2013 Kona Satori.

When upgrading to modern Shimano BR-MT420 4-piston brakes, I discovered that on almost all modern Shimano calipers (including SLX M7120, XT M8120, and MT420/520), the brake hose attachment has moved to the inside of the caliper (closer to the wheel).

On older calipers (like the Shimano M675), the hose attached on the outside, naturally keeping it clear of the spokes. This geometry change means that on older frames, the brake line now runs dangerously close to the spokes if not guided correctly.

THE SOLUTION

This printed guide mounts to the original M5 threaded insert on the seatstay. It holds the hydraulic hose securely and provides the necessary offset to ensure the line stays clear of the spokes during suspension compression.

COMPATIBILITY

  • Bike: Designed specifically for the Kona Satori (2013) seatstay.

  • Universal Use: It functions as a generic M5 Cable Guide and can be used on other frames with M5 mounting points to solve similar routing issues.

  • Brakes: Recommended for any modern caliper upgrade (Shimano MT420, MT520, Deore, SLX, XT, XTR) where the hose exits on the inside.

PRINT SETTINGS

Since this part is mounted near the brake caliper and exposed to the elements, material choice is critical. Do not use PLA as it will deform under heat and tension.

  • Material: ASA (Highly Recommended for UV/Heat resistance) or ABS/PETG.

  • Infill: 60% - 70% (This part needs to be stiff and durable).

  • Perimeters/Walls: 3 or 4 walls for extra strength.

  • Layer Height: 0.16mm or 0.20mm.

HARDWARE NEEDED

  • 1x M5 x 16mm BHCS (Button Head Cap Screw). Note: A standard Socket Head Cap Screw might also fit depending on your clearance, but I had a BHCS laying around which fits perfectly.

INSTALLATION

  • Mounts directly to the frame insert.

  • Ensure the guide is angled correctly so the hose has a smooth curve towards the caliper.

DISCLAIMER

Brakes are a safety-critical component. Ensure the printed part is strong and check that the hose does not touch the spokes or tire under full suspension compression before riding.

Tagi