Modern Geometric Planter Mold – 3-Piece Support-Free Design
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3-piece minimalist faceted planter mold. Designed for support-free printing and easy upside-down concrete casting.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 465
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This is a minimalist, faceted planter mold designed specifically for DIY concrete enthusiasts. The design features a hexagonal base with sharp, crystalline facets that print entirely without supports.
The Design Philosophy To ensure a professional finish, this mold is split into three pieces. By casting the planter upside down, you ensure that the interior bowl is perfectly formed and that any incidental air bubbles rise to the base of the planter rather than the rim.
Specifications:
Exterior Dimensions: 124mm x 124mm x 105mm.
Interior Capacity: ~95mm diameter (tapered for easy unmolding).
Wall Thickness: ~14.5mm (optimized for strength and aesthetics).
Assembly & Casting Instructions:
Preparation: Spray all interior surfaces of the three pieces with a silicone-based release agent, such as 3-IN-ONE Professional Silicone, to prevent the concrete from bonding to the plastic.
Assembly: Fit the three pieces together. Use strong clamps and painter's tape around the seams to ensure the mold remains water-tight and holds its shape under the weight of the wet concrete.
The Pour: Use a high-quality sand-cement mix (like Bomix Sand and Cement). Mix to a "thick pudding" consistency and pour into the upside-down mold.
Vibration: Tap the sides of the mold or use a vibrating tool for at least 45 seconds to settle the mix into the facets.
Curing: Allow the concrete to set for at least 24–48 hours before removing the clamps and de-molding.
Recommended Print Settings:
Material: PETG (preferred for chemical resistance) or PLA.
Walls: 3–4 perimeters for structural integrity against concrete pressure.
Infill: 15–20% Gyroid.
Supports: None required!
***** MAKE sure to wait at least 48 hours before attempting to open the mold with the cement, as you can see from my images, I didn't wait long enough. Don't be like me, wait!