HC Vesper Legally Distinct Handling and Controlling Interface
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Not-Your-Mama's P9000 Handle and Sights
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 246
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
BEHOLD! A HAND HOLD TO BE HELD!
Specifically designed for the HC Vesper's flip-up sight, but you can use it without the HUD if you want to. Uses 4x 94459A767 McMaster-Carr heat inserts and 4x M3x10mm screws. The sight piece is a little fiddly to friction fit into the sight piece, so print it as fine as you can and work it in slowly. You can also just leave it out if you prefer that too. The picatinny lock bars can be resized to your tolerances as well. Print the handle pieces with the end faces down and with some supports. Glue on dat gnob for some artistic flair.
The HUD can still freely swing open and closed. Hopefully the shroud of sorts helps with concealment in low light areas.