Minidisc Sleeve Case - Slim (Maxell, Sony versions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slim Minidisc / MD sleeves based on old cases made by Maxell and Sony
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 83
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Protective sleeve case for minidiscs, similar to manufactured slim cases. Easy to print upright without supports. Modeled after old Maxell and Sony MD sleeves
inner spring latches to retain the disc (works well only when you insert the disc with correct face up)
same thickness but less wide than typical manufactured cases
well on the back for sticker labels
tested recommended setting, .2mm layer, 0% infill. I had great results using PVB or something frosty transparent PLA
NOTE/CAUTION: please test your printer's tolerance and dimensional accuracy by printing a partial cut of the latch mechanism to test, before putting your precious minidiscs inside an un-tested full print, the disc might get STUCK! This is RARE but happened to me once and I had to destroy the sleeve to get the disc out.
1.3: redesigned latch to be more durable
1.2: slightly more tolerance to account for printer variations
1.1 version: improved the spring latch to be more durable