Meshtastic NRF52 Car Solar Node box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
THIS IS A WIP Current file is marked for change solar panel size 110*60, for meshtastic car node
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 320
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
THIS IS A WIP
this solar node is designed to be put on top of a vehicle and secured via magnets, this case is designed to be assembled with the use of silicone, this case is the V1 and may not have accurate measurements for mounting or the lid, in its current state it is unfinished but has all the components needed to make it work
The idea behind this part is to be able to take an NRF board paired with a solar charger circuit and have that inside the included box, there are currently no mounting points for the inside of the box, you are required to secure the components with your choice of adhesive, the solar panel area is designed to use the panel itself as the seal with the use of silicone, there is a pass through for wires into the box itself, this pass through also requires to be sealed, the lid of the box is designed to be attached and sealed with the same method, silicone. the antenna port may not be to size and may require adjustment before or after printing, this case uses the included SMA connector with most metastatic devices, BUT MAY NOT BE THE PROPER SIZE ON THE CASE ITSELF, again, this case is still in design and is subject to change
Warning: Do not print in PLA, it will warp
THIS IS A WIP