Improved magazine clip (rubber band powered) for "Flick 19X With MODS! - A shooting toy pistol. Fully open-source (CAD file Included)"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Instead of printed spring for the magazine clip, this uses a rubber band. Much better. Still other issues 2 be addressed
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 174
- Wydruki
- 2
- Wyświetlenia
- 1708
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Thanks
Many thanks to @myuto_675467 for not only making this design, but allowing this Labs category version of it that allows remixing.
Original open-source CAD files are over there:
Why this listing?
The problem with the printed springs were twofold. One is the "memory" problem, if you left bullets in too long, the spring forgot its original shape and lost its strength. The other was that in its original strength, it was great for when there were not a lot of bullets, but with lots loaded in, the top ones pressed too tightly at the top of magazine and would not be released. If the spring had gotten "memory compressed" and was too weak, then it worked for a lot of bullets, but as the number dwindled, it did not push the last ones up enough.
Also, the bottom part of the magazine (the bottom cap that slides on) was too loose, slid off too easily.
What this listing does
Instead of using a printed spring for the magazine clip, this uses a rubber band to power the spring action of the magazine. It's much better. Could possibly be improved even more.
I also made the bottom part of the magazine (the bottom cap that slides on) have a tighter grip. Even then, it still comes off too easily. I think I could possibly remedy that better by creating a retention-clip type thing that locks the bottom on unless you intentionally trigger a release.
Still pending
There are still other issues to be addressed, such as:
I also see an issue with both the original (printed-spring-powered) magazine and mine here, in which the bullets are not constrained or "not well managed," and they get aimed badly from the top of the magazine and don't make it into the chamber, and the trigger cannot be pulled.
Notes on this:
I tested the smaller and larger bullets, and the smaller seemed to exit the barrel much faster. So, I'm using the smaller bullets.
If the magazine is made to accommodate the larger bullets, then perhaps it means the smaller have too much room? Sometimes they get wrongly positioned at the top of the magazine. I do also wonder if the path from the magazine to the chamber, could be constrained better. ??
Any ideas for how that might be fixed?"