Ender 5 Max DXC and K2 plus upgrade cage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This cage lets you use DXC extruder and K2 plus hot end. Letting you print abrasive filaments like CF or GF up to 350c
- Ocena
- 0 / 5
- Polubienia
- 36
- Pobrania
- 263
- Wydruki
- 0
- Wyświetlenia
- 1284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Standard Digital File License
print it upside down, for the most important surface of the hot end interface, the horizontal top surface. PPA-cf material was my choice for best stiffness and heat resistance.
You will need to modify your front and back covers.
You will need to extend the K2+ thermistor and heater wiring to reach the board.
Paste text below in your config in the correct positions for the termister to read correctly, 350 °C, and run out sensor to work on the extruder, (see pictures for reference)
[filament_switch_sensor filament_sensor]
switch_pin:^!nozzle_mcu:PA1
pause_on_runout: true
# runout_gcode: PAUSE
[thermistor my_thermistor]
temperature1:25
resistance1:260000
temperature2:220
resistance2:738
temperature3:350
resistance3:98
[extruder]
max_extrude_only_distance:1000
max_extrude_cross_section:80
pressure_advance = 0.04
step_pin: nozzle_mcu: PB5
dir_pin: nozzle_mcu: PB4 #!nozzle_mcu: PB4
enable_pin: !nozzle_mcu: PB2
microsteps: 16
# gear_ratio: 42:12
rotation_distance: 6.72 #7.53
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: nozzle_mcu: PB8
sensor_type: my_thermistor
sensor_pin: nozzle_mcu: PA0
#control = pid
#pid_kp = 20.145
#pid_ki = 1.919
#pid_kd = 52.881
min_temp: 0
max_temp: 380