Elegoo Centauri Carbon 2 Chamber Heater
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple heater mount without enclosure for Ali type 100W heater.
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 132
- Wydruki
- 1
- Wyświetlenia
- 4500
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This model allows you to mount the ali style heater to the right side of the CC2. The wire race runs the wires along the side and up to an existing hole in the back. This fully a "no mod" arrangement that does not require any drilling (other than to the base flange of the heater for the magnets). You simply need to buy 8 of the magnet "thumb tacks" from Amazon or Ebay. They are cheap and common and very strong!
The heater base holds two KSD301 thermal switches. I use a 100C as over heat protection, and the other I swap out based on chamber temp desired.
I printed this with ASA. The supports in the channel are not a lot of fun to remove, but everything else worked well.
I've updated this with an improved thermal base and thumb tack holders. This works well overall now in my application and allows just enough space for a voxelpla bento box alongside.
Update : added a wiring diagram. To power this, use a generic two prong plug. I plug that into a timer so it shuts off an hour or so after the print to help with ramping cool down on sensitive parts and so I don't forget the heater is on.
Feel free to remix/update as you see fit!
Other parts:
thermal switches:
https://www.ebay.com/itm/263658318354?var=562768999168
"thumb tacks"
https://ebay.us/m/Lz44mK