1 / 10
Patagonia buckle male - replacement (Black Hole line 15mm strap) — zdjęcie 1
1 / 10

Patagonia buckle male - replacement (Black Hole line 15mm strap)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement buckle (male part only) for chest strap on Patagonia Black Hole 32l backpack

Ocena
0 / 5
Polubienia
3
Pobrania
25
Wydruki
0
Wyświetlenia
177
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Replacement buckle (male part only) for chest strap on Patagonia Black Hole 32l backpack


The original male part broke, while the female part held on and strap was sawn in. So I decided to exactly replicate the male part instead.
In the end I went with an 'assembly' design which allows for simple mounting of the pin which holds the loop of the strap. 

Here is original design in Onshape

I made a bunch of print tuning the design. 
My recommendation:

  • Use as fine printing as possible, I used Prusa Core One Plus - fast detail 0.1mm depostion

  • I used PLA due to the part being so fine I do not have confidence in doing things this fine in PETG

  • Print pin with brim -> and put the brim edge facing towards back of the clip, it will make the strap go over quite 'sharp' edge and hold better.

  • print without raft, but with supports. It will leave weird uneven surface, but better than with raft

  • if surfaces too uneven take a file to it. 

  • print with 100% infill

Tagi