Tripod 1/4-20 screw extension riser 20-70mm tall
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lets you get some space above your tripod screw so you have a gap between your device and tripod head.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
Needed something that would allow me to get some space between my tripod head and a mount I am using. Using just a screw to extend it wouldn't be very stable or strong so I decided to make something that would give me height and stability while retaining some strength. I wouldn't trust this with heavy or expensive items but for lightweight things it should work great. Tolerances are pretty tight depending on what screws you use. I made the opening for the hex head bolt a little bigger since the hillman brand ¼-20 bolts I used had thick lettering. You may want to add some tape to the head of your bolt if it feels loose when inserting. Some superglue to help hold the bolt and nut in place is recommended. I didn't do any destructive testing to see what kind of loads these can take. I would recommend printing with PETG for strength. You could probably also use these as insulators for low voltage stuff with the taller models.
You will need a ¼-20 nut, a ¼-20 hex head bolt that is 0.5 inches long, and some glue to assemble. I also used a soft jaw clamp to help me squeeze everything together since tolerances were tight. I recommend installing the nut on the bottom first.
Video showing it off: