1 / 1
MMU3 Holder CoreOne for 650mm PTFE tube — zdjęcie 1

MMU3 Holder CoreOne for 650mm PTFE tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

MMU3 Holder to use 650mm PTFE tube, no drilling

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
64
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I purchased the original cover for the MMU3 from Prusa to install on the Core One. However, in my opinion, this configuration negates the advantage of a closed build chamber, as the PTFE tube to the extruder creates a large opening.

Basically, I have the problem that with this original configuration, I can no longer heat the chamber properly because the volume is larger and heat can escape through the additional openings.

I tested:

Original MMU3 cover heating time from 21°C to 31°C = 13 min.

With original plexiglass cover from 21°C to 31°C = 6 min.

For this reason, I looked for an alternative to using the original plexiglass cover and found Ruben's version. https://www.printables.com/model/1380032-mmu3-mod-for-core-one-no-drilling

However, since I want to keep the original PTFE tube feed and use original 650 mm long PTFE tubes from Prusa (included with the MMU3 unit; spool to buffer), I designed this holder, which allows the MMU to be mounted closer to the grid infeed without drilling.

Since the PTFE tube is longer, a larger buffer is required. For this purpose, I utilized Mike's remix version:

https://www.printables.com/model/1369695-extended-mmu3-alternate-buffer

To attach the holder to the Core One, heat inserts (M3) can be melted into the holder or rectangular M3 nuts (you probably still have some left over from Prusa spare parts) can be used.

Tagi