Picasso dachshund beltbuckle models for metal sandcasting including clean customizable versions
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Various beltbuckles with Picassos dachshund designed and tested for sandcasting. Includes customizable beltbuckle blanks
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are models to make sand molds for metal casting.
Printed at 100% the beltbuckles are ideal for 40 mm wide belts, at 75% you can use 30 mm belts instead.
When making the mold first place the "base" on a flat surface and make the upper half of the sand mold. Then turn the mold upside down and remove the "base from the mold. Now you can put in the model of a beltbuckle with any design you want (as long as it has the same general geometry as the used base) and finish the second half of the mold. After opening the mold carefully remove the model and add your casting channels. Make sure the front side of the beltbuckle is facing downwards when casting, otherwise it might not cast properly. Once the part has cooled down and you removed the casting channels you will need to drill holes in the two parallel points on the back to attach a bent wire which you can use to fix the belt to the buckle. The other one will need to be filed into a hook to finish off the beltbuckle.
I usually cast with AlSi7Mg0.3, as that's often used for experiments at my work and thus fairly readily available as a molten metal. It also has the benefit of being heattreatable, which, among other things, changes shiny cast surface into a matte finish. This way you can add a lot of contrast to your beltbuckle. Using copper alloys like CuSn6 is of course also possible as you can see in one of the pictures.
The base can be printed on an FFF printer without any problems, as for the models itself it depends on your need. Using FFF you can add fuzzy skin to add more texture to otherwise flat surfaces like I did for the dachshund, but for intricate designs an SLA printer would be better.
I'm not sure whether I can provide the other designs seen in the pictures, as those are based on designs of friends of mine, but they can be used as reference for your custom designs.