Creality Hi -GH lamp

This thing makes the difference!!! Well, at least to me it does....Pics are done in a dark room with just the light ON/OFF (small LED on the camera is always on either way )

Hardware needed:

1. Creality Hi :))))))

2. Strawberry flavored PLA

3. M3x20 mm screw

4. M3 nut

5. Sand paper( optional, maybe needed, i dont know , just make sure you print it of the file and were good)

6. 5V LED strip, 25cm (10 inches)

7. Old USB cable, you need the USB insert and roughly 20cm of cable , so up to you which device stays without charging from now on... 

The power feed is the 5V USB , so no hassle with cabling, external sources or other bull..

What you need is LED strip (5V, just repeating , mistakes were made on my side... ) and an old charging cable ( we all have, dont we :)))) ). Route the cable through the ball joint and the ring FIRST, then solder the LED strip, my strip holds good with just its own low-quality chinese double-sided tape. Then get the 2 posts around the ball and screw them together with the M3x20 mm and the nut, getting the cable in the channel under the pegs.

Once done, this whole contraption slides in the opening of the base. And Voila! You did it!

The light doesnt  gets stuck to the base of the machine as its a snug fit, but if it makes you feel better you can put some double-sided tape on the vertical wall, just precise it well so it looks good.

Print settings:

Material : PLA

Layer H : 0.2 mm - 0.3 mm

Infill: 10%

Perimeters: 4

Nozzle D : 0.4 mm

Would be amazing to see what colours/combos youve made for your loved ones, i sure am having fun and much clearer picture from this upgrade.

Happy printing!