TPU Drain hair catch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Always found the other hair catches or drain mushrooms to be hard to clean, so I made my own.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this hair catch for my tub drain to catch hair better while also still allowing water to drain more easily. I found other designs stood too high above my drain and were hard to clean when enough hair gets wrapped around the center making me not want to use it. I designed this one so if hair gets wrapped around the center there is a split so you can cut it to get it off and/or grab it easier. Additionally I added pegs around the edge for increase chance to catch hair, and additional drain holes.
This is designed for my tub which has a 35mm drain. Could probably be scaled up and down for other sizes.
Print upside down in TPU with your default settings, no supports should be needed. Nothing special needed but if your printer isn't tuned well for TPU you could have a lot of stringing.
Mine is printed with JustMaker 95A Silver TPU at 0.2mm layer height. I used the wrong filament profile so mine doesn't look the greatest (still functional) as my retraction settings were off.
Approx. 1.5hr to print.