Remix of Scraperite Handle V2 MAG With Inverted Blade Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I flipped the blade holder section of this 180º so when you put pressure on the blade, it doesn't pop out of the holder.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I didn't realize until after I'd printed and began uploading the remix that someone else had also done this, but the work is done, so off to the uploads it goes!
I loved the original design, but after using the blade in the original configuration for a bit, I became a little frustrated that it would just pop off with light pressure. Which isn't to say I fault the original designer - I know I could not create this kind of thing. I still love the design, but didn't love my frustrations.