Phanteks Evolv x2 - 5in Raspberry Pi Screen mount

A simple and flush mount for a standard 5 inch Raspberry Pi Screen, fits to the back fan mount with no modifications to the case!

Parts needed:

• Raspberry Pi Screen:
   https://amzn.eu/d/0il68j7 - https://www.aliexpress.com/item/1005007286362902.html

• A 180 degree HDMI Adapter *depending on your specific screen

• 4x PSU Screws | 4x Motherboard Screws | 4x M3 Screws (Any length to max 10mm / Might need a washer)

How to install

Installation is pretty simple, since i know there are so many types of RPI Screens this is a "1 size fits all" type of mount, meaning you can tape, glue or screw it in hopefully without issues! I made sure to include a STEP file in-case you'd need to change it up to fit your screen.

Everyone will likely have their own way of installing it based on what hardware you have on hand, for me i had a bulky DP to HDMI adapter i could cut down to fit in the tight space! You can most likely do the same as i did and slip the cable though the vent holes and down to your GPU if its in the top slot. See the rest of my images for how i modified the power and HDMI cable to fit.

I'll try to explain the existing models i have posted

• Evolv X2 Pi Screen Thin - Bigger Screen - the most basic mount, should fit most screens but might have a bit of the bezel of the screen showing, its likely the highest chance of fitting! So i recommend it to most people

• Evolv X2 Pi Screen Thick - Its the one i used, for this exact screen it's a tight fit with the glass but to really make sure it stays in i personally added glue and tape - The 'thick' part comes in that the frame itself is slightly thicker then needed + Smaller hole that perfectly fits the glass of the 5in screen.

• Evolv X2 Pi Screen Thin - Same as the thick but 4mm instead of 7mm, the screen hole size should fit pronounced screens like the one i linked.