Adjustable Hydrofoil Front Wing Wall Mount (Vertical Display)

This is a custom-designed wall mount to store or display your hydrofoil front wings vertically. Whether you want to save space in the garage or show off your gear in your cave, this mount makes it incredibly easy to drop the wing in and lift it out.

Key Features:

• Universal Adjustable Fit: The mount uses two distinct hooks—a larger one for the thick leading edge and a smaller one for the thin trailing edge.

• Angle-Locking Grooves: The hooks feature a grooved (toothed) base. You can rotate them to perfectly match the unique profile and curvature of your specific wing, and then lock them at that exact angle when screwing the plate to the wall.

• Tested Compatibility: Easily accommodates massive light-wind wings down to smaller high-wind setups. Successfully tested with:

  • Sabfoil Leviathan 1350

  • Sabfoil Medusa 999

  • Sabfoil Balz Pro 909

Interactive 3D View

You can rotate and inspect the assembly in your browser before printing: View Model on Shapr3D Web Viewer

Open Source / Remix Friendly

I believe in true open hardware. Unlike many creators who only upload mesh files (STL), I always provide the high-quality source files to the community to make remixes and mods easier.

• Included File: foil_wing_mount_univ_v03.step

• Feel free to download the STEP file and modify it for different wall spacing or extreme wing shapes.

Print Instructions

Strength is critical here to protect your expensive carbon wings. Follow these settings carefully.

• Material: PLA is perfectly fine for indoor use due to its high rigidity. If you are mounting this in a garage that gets hot in the summer, you should definitely print the provided files in PETG, ABS, or ASA instead to be safe!

• Orientation:

  • Plate: Print face down on the build plate (No supports required).

  • Hooks: Print in their natural upright position (as seen in the slicer screenshot). Minimal supports are needed under the overhanging lips.

• Walls/Perimeters: Use 5 wall loops globally for high strength.

• Infill: 20% is sufficient.

• Crucial Strength Modifier: The model includes a modifier cylinder around the wall-mounting bolt holes. Set this modifier to 10 wall loops to prevent the screws from crushing the plastic when tightened against the wall.

Installation

1. Assemble: Insert the hooks into the back of the wall plate horizontally, the rotate to desired angle.

2. Test Fit: Place your front wing on a flat surface and insert into the mount and adjust the hooks angle accordingly

3. Mount: Hold the entire assembly against the wall and drive your two mounting screws through the plate. Tightening the screws to the wall permanently locks the hooks at their set angles.

Support My Work

If this mount helps keep your gear safe and organized, feel free to support my open-source work!

• GitHub: https://github.com/aniva

• PayPal: https://paypal.me/AndreiIvanov420

Author: Aniva