9mm Magazine Rack for Canik, Walther
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mounted rack designed to fit six 9mm magazines for Canik, Walther, and similarly sized mags.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 189
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution
I was looking for a rack for six 9mm magazines for our Canik and Walther pistols. None, however, seemed right. This print fits on my Flashforge A5M Pro's 220mm bed.
Google Gemini was a help in getting the slot width correct, but it didn't factor in things like the width of the mag butt or the depth including the rack back. It also sent me down the wrong path on angle needed to let the mags hang properly. In this case, I would have been better off with a ruler!
I used Autodesk Fusion for the design work. Those models are here as well.
I don't have the STL properly positioned for print. Rotate it to have it sit on the bottom (where the mags hang out). That will get the layers to be horizontal and better support the weight of the mags.
I used four screw holes but, for my install, am trying just the top two. I'll use the others if it seems to loosen over time.
I design one end to support a label that gets attached with a few drops of crazy glue. Put in a pause at layer 11 for the filament change.