Savi's Protection and Defense Lightsaber Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of jnull3037's Thingiverse model with a spot for Protection and Defense pin, instead of the Jedi symbol.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 162
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Costume Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of jnull3037's Thingiverse model for a display stand for use with Savi's Workshop with a spot for Protection and Defense pin, instead of the Jedi symbol. Also added areas for 6x3mm magnets on both parts to allow access to pin back.
Recommend using supports for base and the recessed area on the back of the insert. I used 3DLAC spray adhesive when printing these parts, so I only used mouse ear brim, and had no problems with warping. You may want to use more brim if you are not using an adhesive.
Base printing notes: Eryone PLA silk - Silver, 0.20mm layer height, Arachne wall generator, 3 wall loops,
Note: I did not have the pin in the insert during the print, I just put it there after for the picture.