Vicks Humidifier Tank Cap Gasket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement TPU gasket for the Vicks VUL525 / VUL545 humidifier tank cap.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-printable replacement gasket for the water tank cap used on the Vicks VUL525 / VUL545 ultrasonic humidifiers.
The original gasket is a soft, ribbed seal that sits between the tank and cap. This model recreates that idea using:
Two raised sealing ribs for better leak resistance
Soft / tapered edges to reduce tearing and pinching
TPU-friendly geometry (prints clean, compresses well)
Flat base so it seats properly on the tank surface
This is designed for TPU (flexible filament). PLA/PETG will not seal properly.
Nominal dimensions (based on measurements / estimates)
Inner diameter: ~80 mm
Outer diameter: ~95 mm
Total thickness: ~4 mm (base + ribs)
Print Settings (recommended)
Material: TPU (95A or softer works great)
Infill: 100%
Perimeters/Walls: 4–6
Layer height: 0.2–0.28 mm
Print orientation: Flat on the bed, ribs facing up
Speed: Slow/moderate (TPU-friendly)
Supports: None
Tip: A very light coat of silicone grease on installation can help with sealing and prevent the gasket from twisting.
Included is the scad file so you can tweak to match your application.