fakeTec Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact and sturdy case for basic fakeTec node (nRF52 Pro-micro DIY)
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 228
- Wydruki
- 3
- Wyświetlenia
- 1289
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Compact and sturdy case for Meshtastic / MeshCore node build. The case has a snap in back cover and a spacer to keep the battery separated from the electronics. The case allows the use of RG178 pigtail for better radio reception. The case has space for installing a 5020 SMD buzzer. Transparent filament can be inserted into the LED holes for better visibility. Tested with a V4 board. STEP file is there, do your worst!
BOM
1x 103450 Li-ion battery
2x 1.7x6mm self tapping screw (or similar)
1x IPEX1 to SMA pigtail (10cm RG178 or RG1.13)
1x 5020 SMD passive buzzer (5x5x2mm, please choose one with hole in center)
Assembly
Insert the buttons into place.
Connect the pigtail to the board.
Route the wire like on the images and lower the board into the case.
Align the the fakeTec board with USB connector hole and notches and slide it into place.
Fix the board with two screws.
Insert and tighten the SMA connector.
INSTALL THE ANTENNA!
Solder the battery.
Place the spacer and route the wires through the cutouts.
Place the battery and close the case back.
Tips.
Depending on your printer calibration the screw holes and led holes may need to be drilled to size. Use 1/1.5mm drill bit for 1.5/1.7mm screw size. If the back cover is loose, you can reduce its size by a few percent.
Changelog
2026.02.25 - v1.0 initial release.