Hold My Handy. For holding your Handy 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A grip attachment for the Handy 2
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 225
- Wydruki
- 1
- Wyświetlenia
- 2966
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Concept
Inspired by the design of another brand I decided to make a grip called Hold My Handy for the Handy 2. It is meant to make usage of the Handy 2 a more ergonomic experience.
The grip comes in two versions. One with and the other without holes. The holes are meant to fit 1/4 UNC threaded inserts. These can be used to screw in a phone ore tablet stand. This way the user can still watch content without having to awkwardly hold something else.
The grips shown in the photos are an older version. The last version was changed to put the Handy 2 right in the middle of the grip so that it can used in both directions.
Printing
The geometry of the grip is such that it can be printed in two orientations.
The first one is on its back. This means that supports will be needed for the overhang of the handle. Any roughness could be handles by wrapping some handlebar tape around them.
The second one is for printing at a 45 degree angle. The example prints also have been printed this way. This orientation results in silky smooth handles without any roughness. Only the top overhangs tend to be a bit sloppy but supports will remedy that. Be aware that printing in this orientation does require some extra supports at the backside for stability. I found that painting on supports until half way up will do just fine.
For strength 3 perimeters and a 15% cubic infill should be enough. The pictured version is printed in PLA and a sturdy as hell.
Links
Below are some affiliate links to hardware that can be used with the grip.
1/4 UNC heat inserts
1/4 UNC mounting screws (1/2 inch, 12 mm long)
1/4 Male/Male tripod screw
Phone stand