Infinitely Extendable Jorgensen F Clamp Holder - With a Bit More Room
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My Jorgensen F-Clamps were 0.5mm too wide to fit the original design.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
My Jorgensen F-Clamps were 0.5mm too wide to fit the original design. I don't know if I have a slightly different model, or some kind of manufacturing change happened, but mine would not sit down in the recess of the original, and the taper of the original interfered with the head of the clamps.
While I was at it, I widened the slot for the bar as well. For good measure.
Overall dimensions remain the same.
These will intermix with the original just fine.
You may find some slight differences in the edge chamfers from the original. I had to derive a new model from the original STLs, as CAD files were not available at the time.