Whistling arrow vane
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a whistling vane for an arrow. It is designed to fit an ACE (5mm diameter) but should work with other sizes to…
- Ocena
- 2 / 5
- Polubienia
- 25
- Pobrania
- 123
- Wydruki
- 2
- Wyświetlenia
- 988
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a whistling vane for an arrow. It is designed to fit an ACE (5mm diameter) but should work with other sizes to be honest. They make a pretty good whistling sound when fired over a decent distance (otherwise the bow noise is dominant). I printed 3 of these in TPU (0.2mm layer height, Colorfabb varioshore TPU), and we stuck them on with double sided tape. Beware: if you print these in hard plastic and don't have enough clearance they will destroy the arrow rest and pressure button!
The design includes the main whistling lip supported by a thin wall, this will need to be cut away, this is to prevent unsupported overhangs and allow for a very sharp and clean whistling lip (necessary). I use a sharp new scapel blade to do this, trimming off some of the thicker lip section in the process. Clean up the inside of the lip a little too if there's any stragglers. Be careful to avoid stringing inside the whistle - worth turning on the avoid crossing walls setting and printing them one at a time.
Attribution:
This design lifts the internal geometry from https://www.thingiverse.com/thing:3130078 but completely transforms the packaging of it. Credit goes to Scarlet Engineering for designing a very good internal geometry.
Print Settings
Printer:
Artillery Sidewinder X1
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Filament:
ColorFabb VarioShore TPU
Natural
Category: Sport & Outdoors