Basic Pulley (2x 608 bearing, 2x M4x30mm, 12mm rope)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DO NOT USE FOR LIFTING PEOPLE OR ANYTHING THAT COULD CAUSE INJURY. Print 2x stator and 1x rotor per pulley. Very easy…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 473
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
DO NOT USE FOR LIFTING PEOPLE OR ANYTHING THAT COULD CAUSE INJURY.
Print 2x stator and 1x rotor per pulley.
Very easy to print except the overhang on the pulley, probably best to print the pulley a little slower. The fins are there to help the overhang.
Printed in PLA+ at 0.25mm layer height, 30% infill but any settings really will work.
The pieces screw together with 2 M4x30mm bolts, with 2 608 skate bearings. The way its designed only the large flats on the stators really take any force and the large area there means the part is very strong. If the rotor part curls on the top, flatten it off a little with a plane or some sand paper. Cut out the fins in the rotor with a pair of side cutters, they can help grip the rope but you could sand them down.
I've tested putting around 60kg on it and bouncing a little and it didn't make any noises or anything. I'm using it in a free weights setup, probably up to about 40kg. I'd guess it might take more than 100kg statically. Because of the design it isn't hugely reliant on layer adhesion but definitely this is used at your own risk.
Its designed to take up to 12mm rope.
Be careful if any parts are rubbing because it will wear through the plastic very quickly - this happened on the first iteration when the rotor curled at the top and was rubbing one of the plates, nearly went all the way through after about 10 mins of use.
Print Settings
Printer:
Artillery Sidewinder X1
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
30
Filament:
Jake3D Eco PLA Tough PLA
Black How I Designed This ===================
This is a very simple pair 3D shape in Freecad. The fins on the interfacing surfaces allow a press fit without having to dial the printer that well. The fins in between the two sides of the rotor are there to act as supports - keeps the print time low while supporting that top surface pretty well. Single wall thickness means they're easy to remove and even sort of help grip the rope which helps the rope not rub against the pulley at low loads.
Category: Household
