1 / 3
Reinforced Hex-Drive Filament Winder (6mm Allen Key Remix) — zdjęcie 1
1 / 3

Reinforced Hex-Drive Filament Winder (6mm Allen Key Remix)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a functional remix of the Filament Spool Winder by cheesus.

Ocena
5 / 5
Polubienia
3
Pobrania
26
Wydruki
0
Wyświetlenia
90
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

The Problem

The original design is excellent, but I encountered three main issues:

  1. Durability: The integrated plastic shaft is prone to snapping. I snapped mine before I could even start the first spool.

  2. Compatibility: The original uses a 12mm hex grip. Most standard consumer drills (mine included) have a maximum chuck capacity of 10mm, meaning you would need a 12mm socket adapter just to connect it.

  3. Printability: The original integrated shaft requires supports. And I don't like supports :-)

The Solution

I redesigned the core by removing the integrated shaft and creating a 6mm hexagonal through-hole instead.

Key Improvements:

  • Indestructible Drive: By using a standard 6mm Allen key (hex wrench) as the axle, you replace weak plastic with solid steel.

  • Universal Fit: A 6mm hex key fits perfectly into any standard drill chuck without needing additional adapters.

  • Support-Free Print: This remix prints without any supports. And I don't like supports :-)

Assembly & Printing

  • IMPORTANT: Use the nut from the original model.

  • Print Settings: I recommend at least 3-4 walls and 20%+ infill. I used 4 walls with 20% gyroid.

  • Support: Not needed!

  • Hardware: You will need a standard 6mm Allen key.

  • Setup: Simply slide the Allen key through the hexagonal hole.

  • Operation: Tighten the long end of the Allen key directly into your drill and you are ready to wind!