Reprap Fisher Hall Sensor Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket for the RepRap fisher to allow the use of a NJK-5002C Hall sensor instead of the homing microswitches Hall…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 153
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A bracket for the RepRap fisher to allow the use of a NJK-5002C Hall sensor instead of the homing microswitches
Hall sensor available from here: http://www.banggood.com/NJK-5002C-Hall-Sensor-Proximity-Switch-NPN-3-wires-Normally-Open-Type-p-936554.html
Designed in Onshape https://cad.onshape.com/documents/43651e2c2ccc40319dedcd6e/w/4b43a6d1793a478896207684/e/8a68f2ddec6540609d254ef4
Print Settings
Printer:
Reprap Fisher
Resolution:
0.2mm
Infill:
40%
Post-Printing
The brown wire goes to 5V (preferably) or 12-19V input.
The blue and black wires are wired in to the X, Y and Z sensor inputs, blue is sense and black is ground.
The sensor is open collector, so pulls the signal down to ground when it is triggered.
Set your endstop configuration int the duet as follows
M574 X2 Y2 Z2 S0 ; set endstop configuration (all endstops at high end, active high)
Category: 3D Printer Parts