1 / 3
Valve Index Ghetto GunStock (strong, cheap, quick to print) — zdjęcie 1
1 / 3

Valve Index Ghetto GunStock (strong, cheap, quick to print)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Designed this Valve Index Gunstock because all the other pedal like controller parts on Thingiverse were too flimsy…

Ocena
0 / 5
Polubienia
5
Pobrania
18
Wydruki
0
Wyświetlenia
859
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Designed this Valve Index Gunstock because all the other pedal like controller parts on Thingiverse were too flimsy and brittle to be used by me (at least in PLA). Plus I was too lazy to print out the entire stock length on my 20x20x20 printer.

So I designed this for a 60-70cm long, 28,4mm diameter wooden Staff, commonly found in the Drapes and Curtains section of any halfway decent Hardware store.

Add about 6x M4x30 Screws with M4 Nuts and this set should stay pretty firm in Position.

Once mounted on the staff, cut out some aluminum foil in the size of the Curved Pedal like grip Panels.

DIY Instructions:

Carefully heat the pedal like structures with a heatgun set to 1. Once the PLA becomes formable, put the Aluminumfoil on it and now carefully place your Valve Index Knuckles controller in the Position you want, hold it for a few seconds or blast the hot piece of plastic with some air from a Compressor.

Voila! you now have a sturdy and solid adapted pedal for your Knuckles controllers to rest in. It could even be formed into your most comfortable holding Position.

Incase your Knuckles controller dont register any grips anymore, try to space the beams of the pedal further apart, you controllers should registers a grip again.

Disclaimer: I am not responsible for you or your stupidity, if you burn yourself or your knuckles controllers you better get your genes out of this pool.

Print Settings

Printer:

Renkforce RF 100 XL

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0,15 - 0,25

Infill:

15-25

Filament:

Stronghero 3D PLA

Blue / Red


Notes:

220°C Extrudertemp
Rafts: not needed

Supports: only for the stock if you print it upwards like me.

Dont overtighten the Screws!!!

Post-Printing

Ghetto Stock Assemble

You need:

  • electric Heatgun or Gasstove
  • aluminum foil (12cm x 7cm, 2 or 3 layerd)
  • some thin gloves if you are squeamish
  • Left and Right Index Knuckles Controllers
  • 6M4x30 screws and 6 M4 Nuts
  • (wooden) Curtain Staff 28,4mm Diameter, Length (as long as you need it to be)

Heat the Grips up over a gasstove flame or with a low powered heatgun (with PLA even a hairdryer works). Dont make the plastic too hot and be careful that the beams of the pedal dont stick to each other.

Caution from here on out!!!

Once malleable, strap on your Index Knuckles controller and form the PLA pedal onto the contours of your Index Grip. Cool the formed Grip by blowing some air on it.

Repeat for second controller.

Category: DIY

Tagi