1 / 5
Oneblade Castle Spire Travel Case and Stand — zdjęcie 1
1 / 5

Oneblade Castle Spire Travel Case and Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a Deliverance II themed travel case for the Oneblade shaver

Ocena
0 / 5
Polubienia
3
Pobrania
4
Wydruki
0
Wyświetlenia
46
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a travel case and stand for the Oneblade Deliverance shaver.

Print Tips

  • Spire- Print with supports but have them blocked after the lower hinges.

  • Shield- print with pegs down and with supports. Add a pause when the logo gets added to the shield (I printed with first layer = .20 layers = .15) the pause for me was at layer 55

  • Infil- I printed with 10%

The TPU pieces are meant to be printed separate and then pushed into their respective places inside of the spires. I will warn you, clean up the stringing on the inside first (if any, depends how well your printer is tuned) and then put the TPU pieces in; they will be hard to take out.

The hinges use a small piece of filament to use as the pin in between them

The Banners and Logo are meant to be hot glued into place in the holes on the outside of the spire

                                                |_|_|_|_|_|_|

The holes on the top             \ |      |*/

and bottom are for magnets/  |     |*\

(6mm x 2mm)                       ____________

I recommend finding stronger ones than I did but here is the link https://www.amazon.com/dp/B0956WH813?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2

Tagi