Impact Resistant Omnipod and Insulin Pen Travel Carrying Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This case is designed to carry two insulin pens and 6 needles.
- Ocena
- 4,667 / 5
- Polubienia
- 84
- Pobrania
- 377
- Wydruki
- 2
- Wyświetlenia
- 1909
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
***********************************************************
Update
***********************************************************
Edited the Omnipod retention tabs in the Omnipod case to allow for better overhangs.
***********************************************************
Background
***********************************************************
These cases were designed out of a necessity when traveling with our daughter that has Type 1 Diabetes. We didn't like what was available commercially. On the affordable end of the spectrum, either the designs were soft sided and provided little protection, or were cheaply made plastic molded cases that would protect the pens, but shatter on impact with any object. Enter our case. I wanted something that would be impact resistant, but not so soft that it would be too flexible. That's why we went with 68D shore hardness TPU. It provides the impact resistance of some of the hard cases, without the worry of cracks and holes forming. It prints on a single build plate, and no additional hardware required. If you're Type 1 or Type 2 insulin dependent, and would like to see an accessory to make your life easier, please shoot me a message!
***********************************************************
The Cases
***********************************************************
I've designed two cases. One version that holds two insulin pens and six pen needles, and one that holds up to four insulin pens, and two Omnipod 5s. These cases are designed to protect your pump, insulin pens , and pen needles. They have been tested with Humalog Jr. and Lantis pens, but should be compatible with most pens. The image is of an earlier revision, that only held Humalog pens. The Lantis pen is about 17mm longer. If you find they aren't compatible with your pen, please let me know, and I'll attempt to make adjustments for you!
***********************************************************
Filament Selection
***********************************************************
This was designed to be printed in 68D shore hardness TPU, which provides excellent impact resistance, layer adhesion, and only minimal flexibility. It can be printed in PETG or PLA, but the case is less resistant to impacts with those materials. The filament we went with was Bambu Lab's TPU for AMS, because it was the most readily available at the time, though any TPU with those specifications should work just fine! More flexible filaments COULD be used, but I haven't tested the overhangs for the hinges with those filaments, so your mileage may vary. If you do use a more flexible filament with/without success, please let me know!
In the images, the Green is the TPU, and the black one was printed in PLA.
***********************************************************
Print Settings
***********************************************************
My cases were designed to be printed in place on any printer with at least 210x80mm of build plate area for the Insulin Pen case, and 230x210mm for the Omnipod Case
My case was printed with 2x walls and 15% infill, this has proved to be a resilient addition to our T1D travel kit. The case prints in the open position, and assuming your overhang settings are fairly dialed in, should only require flexing once or twice after removing from the build plate to ensure a smooth opening and closing process.