120MM Magnetic HEPA Fan Adaptor and Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adaptor to fit a robo-vac HEPA filter onto a 120mm axial blower fan. Accepts 4 12mm magnets in the bottom.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I wanted an internal HEPA filter for my Centauri Carbon so I could print carbon and glass fiber filaments. An internal filter is better for high-temp filaments like nylon that need the chamber to be hot.
This model fits over 120mm blower-style fan ducts, like this one here. It accepts an 80x40mm robo-vac HEPA filter like the ones used in Uncle Jessy's side mounted filter.
You could probably cut some activated carbon foam to put in behind the HEPA filter, but I haven't personally tested this.
The bottom holes snug-fit 12mm round neodymium magnets that hold pretty well to the CC's side walls. If your tolerances are off, the magnets can be held with superglue/hot glue.
The adapter needs to be sealed around the fan with hot glue/silicone to work. I prefer hot glue as it's also the only thing holding it together :)
If you're using a Centauri Carbon, you can easily replace the "side fan" with this mod - simply unscrew the fan cover in the top-rear, unplug the original side blower fan, plug in the new fan and feed the wire out of the side fan's duct. Change your slicer settings to enable the auxiliary fan on all layers. You don't even need to remove the old fan, and now you can control the filter through the firmware. Easy as.
