Dry Box - PolyDryer Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Single piece adapter to use the Ultimate Cereal Container Filament Drybox with the PolyDryer.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 299
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was inspired by @GunplaMark's, @SparrowHawk's, and @endri's adapters for the PolyDryer. I had trouble aligning the vents on the PolyDry with the holes on the cereal container. It was cumbersome to remove the cereal container from the the dryer because the seals were so tight.
This version was created from scratch as a single model that eliminates the alignment problem - at least for the cereal containers that I use. I also slightly increased the size of the vent holes so the container could be easily lifted off and separated from the dryer. I haven't noticed any leakage around the seals, but a small amount shouldn't have a significant effect on performance. The big hole in the middle is simply an attempt to save material.
I printed this with ASA which tends to warp on such a long piece. Wide brims helped eliminate this problem.
See @SparrowHawk's remix for the hex gasket ring and seal. The Fusion project is included so tweaks can be easily made to handle cereal container variations.