Dual Extruder Fan Shroud for Neptune 2S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Commodity parts and 3D-printed dual extruder setup for Neptune 2/2S
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 769
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Notes/Warning
Since posting this model, I've noticed that the fan hits the heat block too much, causing under-extrusion and consequently, z-banding. I'm working on a new version with a retractable nozzle and cooling improvements.
Hardware Requirements / Parts List
- 3x M4 Hex Nuts and Hex Bolts (https://www.bunnings.com.au/pinnacle-m4-x-30mm-stainless-steel-hex-head-bolts-and-nuts-12-pack_p0247305)
- 3x ¼" od x ½" l compression springs (https://www.bunnings.com.au/century-spring-corp-6-4-x-12-7mm-compression-spring-3-pack_p3970840)
- 2x M3 Nuts (https://www.bunnings.com.au/pinnacle-m3-x-20mm-black-ruspert-round-head-bolts-and-nuts-12-pack_p0257677)
- Elegoo Neptune 2/2S with the stock, 1-in-1-out hotend (suspended by this shroud)
- Micro-Swiss All-metal Hotend kit for Ender 3 (attached to the aluminium fixing plate)
- BigTreeTech Octopus v1.1 board (or any with multiple heater outputs)
Printing
Print both parts upside down with support touching buildplate only.
Assembly
- Turn everything off, make sure it's cooled down and remove your existing fan shroud.
- Attach this fan shroud.
- Thread a thermistor, heater cartridge, and bowden tube through the middle of the shroud.
- Assemble the OEM hotend.
- Slide M4 hex bolts into the Stabilizer from the bottom.
- Secure hotend to the stabilizer. With the M3 hex nuts in the back.
- Slide spring down the hex bolts from the top.
- Insert Stabilizer into the fan shroud from the bottom. Taking notice of the 3 corresponding holes.
- Screw on hex nuts from the top, using a 7mm socket wrench head to finely adjust the height.
- Attach fans. If the blower fans aren't cooperating, I find angling them slightly works to attach them. (Tolerance in a lot of places are crap I know, but it works!)
Software
You'll need to configure cura and the firmware yourself. The theoretical Nozzle Offsets should be (x=0, y=-30). Probably a good idea to start from there and finely adjust using a set of calipers and a calibration cube split across the middle for the 2 extruders.

If it helps, I have an extremely poorly documented set of Klipper/Cura configs backed up on github: https://github.com/thinkier/FrankenPrinter_Configs