CKCS U1E 65W Type-C PD case for Amass XT60
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for CKCS U1E 65W Type-C PD module with connection through Amass XT60
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 320
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Enclosure for CKCS U1E 65W USB Type-C PD Module (XT60 Input)
This enclosure is designed for the CKCS U1E 65W Type-C Power Delivery module, featuring power input via Amass XT60 connector.
Purpose
The primary goal of this design is to enable charging of USB-C devices — including smartphones, laptops, tablets, and other PD-compatible equipment — directly from FPV Li-ion and Li-Po battery packs.
The setup has been successfully tested with:
3S Li-ion (nominal 11.1V, 12.6V fully charged)
4S Li-ion (nominal 14.8V, 16.8V fully charged)
6S Li-ion (nominal 22.2V, 25.2V fully charged)
Input Voltage Range
The CKCS U1E module supports an input voltage range of:
9V – 32V DC
This makes it compatible with common 3S–6S Li-ion FPV battery configurations.
Wiring
The module is connected to the XT60 connector using:
18 AWG silicone-insulated wire
18 AWG was selected to safely handle the input current required for 65W output power while maintaining flexibility and mechanical durability inside the enclosure.
Design & Assembly
The model consists of two separate components:
Base
Cover
The enclosure can be assembled:
Without adhesive (press-fit) for easier maintenance and repairability
With adhesive for increased structural integrity
It is strongly recommended to secure the XT60 connector with glue to prevent movement or stress on solder joints during battery connection and disconnection cycles.
Printing
Successfully printed using:
Sunlu PLA
eSUN PETG
Both materials were printed using standard/default slicer profiles.