Lian-Li 011 Dynamic Drive Cage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3.5" drive cage replacement
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
I made this 3.5" drive cage because I lost the one that came with the case, and I really needed to use my old HDD. Maybe I'm not the only one with this problem, or maybe there is someone out there who doesn't want to use the stock hot-swap ones, so I decided to publish it.
The one in the picture is a little different from the published model because it's the first version. In this one, I added a second row of holes for the HDD screws and made them larger and longer, then I shortened the wings with the mounting holes to fit the plate, and added a cutout to make it easier to align the nut. Also, the mounting holes are a bit bigger, from 3 to 3.5mm
It fits on top of one of the removable back covers that come with the case; you just need to use M3 screws and nuts (with a washer between the nut and the plastic) and mount the HDD inside it with its scews
Print it vertically (it shouldn't need supports, but it depends on your printer and material). I used R3D PLA PRO at 0.2 layer, 4 walls, 20% 3D honeycomb infill, and it holds perfectly without any warping or deformation inside the case, but if your system (especially your PSU) runs particularly hot, use PETG or ASA
Leave a LIKE, and post a MAKE if you found it useful!