TrappCaddy – Backrest Storage for Stokke Tripp Trapp (Snap-In, Full Width)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Full-width snap-in storage bin for Tripp Trapp. Easy to clean, strong hooks, and far cheaper than original.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 113
- Wydruki
- 1
- Wyświetlenia
- 460
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Standard Digital File License
TrappCaddy is a full-width snap-in storage bin designed to mount behind the backrest of the Stokke Tripp Trapp chair.
After seeing other printable versions that didn’t fully convince me, I designed TrappCaddy to use the entire width of the chair, maximizing storage space while keeping a clean and integrated look.
The shape features large radii and smooth organic transitions, making it easy to wipe clean — ideal for bibs, wipes, small toys, cloths, or everyday essentials.
TrappCaddy snaps securely into place using two integrated hooks.
No screws, no hardware, and no modification to the chair required.
Compared to the original Stokke storage solution (priced at over 30€), this is a practical and affordable alternative you can print yourself.
Design Features
Full-width design for maximum capacity
Organic shape with large radii for easy cleaning
Snap-in mounting with two strong hooks
No screws or additional hardware required
Fully 3D printable
Significantly cheaper than the original accessory
Printing Instructions
The model is split into two halves:
Print both halves.
Remove the integrated brims and supports
Glue the halves together at the lap joint.
Install by pushing at the hooks until they slip into position
The design prints in an orientation that maximizes hook strength.
no supports needed, the ones needed are integrated in design and the integrated brim improves bed adhesion.
Recommended Print Settings
Material: PLA, PETG
Min 0,8 mm perimeters recommended
Print orientation: As provided
Notes
Fit may vary slightly depending on chair tolerances and paint thickness
PETG is recommended if higher durability is desired
Fully compatible with Tripp Trapp tray holder
Other models of interest:
Disclaimer
Always ensure the bin is properly snapped in place before use. This design is intended as a practical storage solution only. Muffelkraft assumes no responsibility for improper installation or misuse.