Case for Olight Marauder 2

This case for the Olight Marauder 2 flashlight, allowing you to wear your Marauder on your belt. The case is designed so that all controls remain accessible.

Partslist:

4x - M4x12mm Countersunk
4x - rubber spacer (normally included in the set with the Tek Lok)
4x - M4 melting insert
1x - Tek Lok with 9 holes (hole spacing 19x19mm)

PETG

No support

0.4 nozzle

5 wall lines

25% infill

5 bottom and top layers

Disclaimer

1. Digital Quality & Compatibility

This model is provided "as is." I make no guarantee that the model will function flawlessly with any specific slicing software or 3D printer model. The buyer is responsible for verifying the technical requirements for printing.

2. Print Success
The quality of the physical object depends significantly on factors beyond my control (e.g., printer settings, material selection, ambient temperature, calibration). Liability for failed prints or material waste is excluded.

3. Use & Safety

* Not a Toy: Unless explicitly stated otherwise, the models are not certified as children's toys.

* Limitation of Liability: I am not liable for damages resulting from improper use, post-processing (e.g., sanding, painting), or use of the printed object.

* Food Contact: The models are not food-safe by default unless special materials are used and the model has been designed accordingly.

4. Statutory Warranty
The statutory rights of consumers with regard to digital products remain unaffected, unless they can be effectively excluded. In the event of demonstrable technical errors in the file (e.g., a defective mesh), please contact me for a replacement.